Brush cleaner

This equipment is suitable for cleaning round or round fruits and vegetables. The fruit and vegetable raw materials move forward under the rotation of the brush, and the washing degree is high.

√Choose the wire diameter of the harder brush roller to achieve the purpose of cleaning and peeling the original fruit;

√Design according to requirements and choose soft brush roller wire diameter to achieve the purpose of cleaning, waxing and polishing the raw fruit.

1.Overview

Brush peeling washing machine is the fruit and vegetable washing and peeling equipment produced by our company. It has the characteristics of novel and tight structure, energy saving and high efficiency, high production efficiency, thorough cleaning and peeling, little damage to fruits and vegetables, and wide application range. This machine is widely used for peeling and cleaning carrots, potatoes, potatoes and other fruits and vegetables, especially suitable for cleaning and peeling fruits and vegetables growing in soil.

2. Structural features and working principle

The brush peeling cleaning machine is mainly composed of a frame, a transmission reducer, a sprocket cover, a spray pipe, a brush roller, a water hopper, a discharge door cover, a discharge hopper, a door cover latch and other components.

Its working principle: the raw materials of fruits and vegetables enter the machine body evenly through the conveyor, and the brush roller rotates under the drive of the transmission reducer, so that the material is constantly turned over, thereby generating friction. At the same time, the spray head sprays high-pressure water to wash the surface of the material, and It is sent to the discharge hopper under the thrust of the spiral brush roller. The cleaned sewage, silt and fruit and vegetable skins flow into the water tank through the gap of the brush roller and are discharged from the sewage outlet. The peeling time depends on the flow speed of the material from the inlet to the outlet, and the speed can be adjusted. The machine can be made according to the specific needs of customers, and a circulating cleaning device can also be added.

3. Installation, adjustment, use, operation

1. Tighten all bolts on the whole machine.
2. Adjust the level of the whole machine, clean the inside and outside of the whole machine, and keep it clean.
3. The bearings and reducer parts are required to be well lubricated, and lubricating oil with the specified label is added regularly.
4. Turn on the power supply of the transmission reducer and confirm that the rotation direction of the brush roller is consistent with the direction indicator.
5. Run the machine for 2 minutes. After confirming that the machine is running normally, feed the material to the entrance of the brush cleaner. Then connect the spray pipe to spray water.
6. The feed should be even and do not impact.
7. When peeling and cleaning materials, the speed of the brush roller can be controlled by the hand wheel on the transmission reducer to achieve the degree of peeling and cleaning of the materials.
8. When the machine is out of service, the inside and outside of the machine must be kept clean, and the residues on the dehairing brush must be cleaned.
9. Check the reducer regularly. If you find any undesirable phenomena, you should stop it immediately and use it after removing the obstacles.